Sigfox Adapter

The Sigfox protocol adapter exposes an HTTP endpoint for connecting up with the Sigfox backend for publishing telemetry, events and use command & control.

Info

This protocol adapter is not considered production ready. Its APIs might still be subject to change without warning.

Pre-requisites

This Sigfox adapter only connects to the Sigfox backend system (backend.sigfox.com). It does not allow direct access to Sigfox devices.

So you need to set up your Sigfox devices on backend.sigfox.com and then configure the callbacks connect to your installation of Hono.

Devices and credentials

In a nutshell, the Sigfox adapter requires a single device identity, acting as a gateway device. This identity will be used to connect to Hono. All devices registered with Sigfox (the actual Sigfox devices), will be registered in Hono to allow this first identity as their gateway device.

Setup example

The following sub-sections walk you through an example setup.

Registering devices

This example assumes that the Sigfox protocol adapter is available as https://iot-sigfox-adapter.my.hono.

Create a new gateway device with the following registration:

{
  "device-id": "sigfox-backend"
}

Create new credentials for the gateway device. For example, using a username of sigfox and a password of test12:

{
  "auth-id": "sigfox",
  "device-id": "sigfox-backend",
  "enabled": true,
  "secrets": [
    {
      "pwd-plain": "test12"
    }
  ],
  "type": "hashed-password"
}

Create a new device, referencing the previous gateway device. The device id must be your Sigfox device ID (e.g. 1AB2C3):

{
  "device-id": "1AB2C3",
  "via": "sigfox-backend"
}

Setting up callbacks

Create a new “Custom” callback, with the following settings (replacing <TENANT> with the name of the tenant):

Type: DATA – UPLINK
Channel: URL
Url pattern: https://iot-sigfox-adapter.my.hono/data/telemetry/<TENANT>?device={device}&data={data}
Use HTTP Method: GET
Headers
- Authorization – Basic … (see note below)
Send SNI: ☑ (Enabled)

Tip

At the moment you need to manually put in the Authorization header, you cannot put the credentials into the URL, as there is a bug in the Sigfox backend, which cannot be fixed by Hono. The backend does not properly escape the @ character, and thus sends foo%40tenant instead of foo@tenant to the Hono protocol adapter.

As a workaround, you can explicitly set the Authorization header to a value of Basic <base64 encoded credentials>. You can encode the credentials using:

echo -n "sigfox@tenant:password" | base64

To get the full value, including the Basic you may use:

echo "Basic $(echo -n "sigfox@tenant:password" | base64)"

Enabling command & control

It is possible to enable command & control as well. For this you need to:

Switch the Type of the DATA callback from UPLINK to BIDIR
Add the ack query parameter to the Url pattern, e.g. https://iot-sigfox-adapter.my.hono/data/telemetry/<TENANT>?device={device}&data={data}&ack={ack}

Tip

Sigfox allows only a very specific payload in command messages. You must send exactly 8 bytes of data. It only supports one way commands.

Events

You can send events by using the path /data/event on the URL.

Consuming data

Use the standard way of consuming Hono messages.

Known bugs and limitations

Only the simple URL and only data (no service or device events are currently supported.