Getting Started
This guide will lead you through the installation steps to set up the openPASS simulator and run your first simulation. The process is described for Windows and Linux as target platforms. Please check the System Requirements for the required hardware setup.
The installation manual is structured as follows:
Setting up your system
Installing Prerequisites contains instructions for installing the thirdparty software required by openPASS
Installation of the simulator
Installing openPASS describes how to compile and run openPASS once all prerequisites are installed
Warning
Not Recommended to install this way. Not finished and fully tested yet.
Setting up Conan
Building with Conan contains the instructions to set Conan up.
Installation of the simulator
Building with Conan describes how to compile and run openPASS once all prerequisites are installed
Run a default simulation
Tutorials shows how to run your first simulations
Further guidance
CMake Variables and Options holds information about available variables and options for the cross-platform build environment CMake
Working with Visual Studio Code describes the basic setup for Visual Studio Code